XenoPhage :verified:<p>UGH... spent an hour trying to get my Ender5 to print properly. I don't know how to fix this.. I have an Ender 5 with a BLTouch. The nozzle is too high when it tries to print, so it's just air printing. Not very good.</p><p>Yes, I know about z-offset. I've set it. Over and over again. But it always seems to ignore it and I don't know why.</p><p>One further data point, I'm using Octoprint. So maybe I have to put the z-offset in there somewhere? Google hasn't been super helpful, so looking for suggestions.</p><p><a href="https://infosec.exchange/tags/3dPrinting" class="mention hashtag" rel="nofollow noopener" target="_blank">#<span>3dPrinting</span></a> <a href="https://infosec.exchange/tags/TechSupport" class="mention hashtag" rel="nofollow noopener" target="_blank">#<span>TechSupport</span></a> <a href="https://infosec.exchange/tags/ZOffsetIssues" class="mention hashtag" rel="nofollow noopener" target="_blank">#<span>ZOffsetIssues</span></a></p>
#zoffsetissues
0 posts0 participants0 posts today
#TimeLapse of why I wasn't 15 minutes early to work this morning.
If I go up .01mm it won't adhere. If I go down .01mm, it can't get out of the nozzle.